Filtyp
TiO2(B) crystals were found to be isomorphic with those of its precursor, K2Ti4O9. The former crystals had a large number of facetted voids, 3–30 nm, formed as a result of the removal of potassium and water in preceding hydrolysis and calcination steps, respectively. TiO2(B)-supported vanadium oxide catalysts with loadings in the range 0.25−10 theoretical layers were prepared by impregnation of th
A PID design method is presented. The work done is part of anattempt to find an automatic tuning algorithm for two times two systems inthe process industry. The method tries to minimize the impact of load disturbances. The method was mainly developed because previous designmethods with the same objectives could not handle the processesobtained in decoupled systems.
We investigating the role of anticipation and attention in a dynamic environment in a number of large scale simulations of an agent that tries to negotiate a number of gates that continuously open and close. In particular we have looked at learning mechanisms that can predict the future positions of the gates and control strategies that will allow the agent to pass through the gates unharmed. The
Families of asymptotically regular LDPC block code ensembles can be formed by terminating (J, K)-regular protograph-based LDPC convolutional codes. By varying the termination length, we obtain a large selection of LDPC block code ensembles with varying code rates, minimum distance that grows linearly with block length, and capacity approaching iterative decoding thresholds, despite the fact that t
The development and introduction of heat pumps provides an interesting illustration of policy influence and effectiveness in relation to energy technology innovation. Heat pumps have been supported by several countries since the 1970s as a strategy to improve energy efficiency, support energy security, reduce environmental degradation, and combat climate change. Sweden and Switzerland have been es
Confrontations, break-up, dissociation , the Other – all of these concepts could be seen as troubling, disturbing or problematic, most certainly when the context is music education in a globalised world. In this chapter however, these concepts of instability and insecurity are used to discuss the potential value of tensions and disruption in practising creative music education.
Large anions are attracted to hydrophobic surfaces while smaller, well solvated ions are repelled. Using a combination of explicit solvent and continuum model simulations we show that this leads to significant ion-specific protein-protein interactions due to hydrophobic patches on the protein surfaces. In solutions of NaI and NaCl we calculate the potentials of mean force and find that the resulti
The two most common strategies for verification and validation, inspection and testing, are in a controlled experiment evaluated in terms of their fault detection capabilities. These two techniques are in the previous work compared applied to code. In order to compare the efficiency and effectiveness of these techniques on a higher abstraction level than code, this experiment investigates inspecti
This thesis consists of an extensive introduction followed by seven papers (A-F) on low-level analysis of microarray data. Focus is on calibration and normalization of observed data. The introduction gives a brief background of the microarray technology and its applications in order for anyone not familiar with the field to read the thesis. Formal definitions of calibration and normalization are g
Flow maldistribution in plate heat exchangers causes deterioration of both thermal and hydraulic performance. The situation becomes more complicated for two phase flows during condensation where uneven distribution of the liquid to the channels reduces heat transfer due to high liquid flooding. The present study evaluates the thermal performance of falling film plate condensers with flow maldistri
Slutrapport kring förstudie för utveckling av området förpackningar för närproducerade livsmedel vid Skånes Livsmedelsakademi
In this article an analytical equation for calculating the theoretical arithmetic mean surface roughness, Ra, in the case of turning using a tool with a circular nose radius is presented. The calculated Ra-values are verified by experimental results obtained from machining of 7 different workpiece materials. For all measuring series results were obtained that were either better or worse than the t
